Yesterday I picked up the final frame from the company Hydrocut in Neustadt bei Coburg. They did really nice work on it with waterjet cutting so the groundplate is only done at the outer lines. I will go on with further improvements like sink the wires into the plate. Further there will be some changes to shrink the weight down to a minimum to get the best results of flight time, sturdiness and response characteristics to commands. With the heavy aluminium prototype I did a flight test 30 minutes ago and get a result of 12 minutes stopping the motors at 10.9V with 1130gr lift off weight. I have to change the settings in the imu for the voltage checking soon because these settings will stop everything too early. I am looking forward to 15 mins of flight time with this tiny heavy lift hexa. I am sure this will be a gamechanger in the market if it will go for final production. Thanks for everyone who is interested in this project so far. I plan to make a funding project for this soon but I’m not sure right now.